The current design of 90% of these dolls with the single insert pass thru hole, is the worst possible design.
Once you get your dick to bend the wrong way, it's just a pop out on the other side.
Seriously designers... have you tried to use these products you sell?
A full tunnel depth of 4"... Not good.
Combining both front and backside into one device... Not good
Supposedly functional mouths that can accommodate maximum diameter of 1.1" ... Not good.
The cheaper dolls,
The peal seal hole that leaves too small of a hole to function without scratching the rod no matter how much lube... Not good.
All if this can be fixed at nearly no cost change to the products...
Cheap type vinyls...
Peal the seal.. just add 1/4 inch, 6mm wider on each side, and 3/4" 19mm over all length.
Increase the mouth diameter by 1/4 inch 6mm..
The better vinyl dolls... Loose the single universal pussy ass combo insert.
Make 2 tunnels on the doll just like the cheap ones, slightly larger to accommodate the insert wall thicknesses. Include 2 closed end 6 inch long (not 4") thin wall inserts.
Once you get your dick to bend the wrong way, it's just a pop out on the other side.
Seriously designers... have you tried to use these products you sell?
A full tunnel depth of 4"... Not good.
Combining both front and backside into one device... Not good
Supposedly functional mouths that can accommodate maximum diameter of 1.1" ... Not good.
The cheaper dolls,
The peal seal hole that leaves too small of a hole to function without scratching the rod no matter how much lube... Not good.
All if this can be fixed at nearly no cost change to the products...
Cheap type vinyls...
Peal the seal.. just add 1/4 inch, 6mm wider on each side, and 3/4" 19mm over all length.
Increase the mouth diameter by 1/4 inch 6mm..
The better vinyl dolls... Loose the single universal pussy ass combo insert.
Make 2 tunnels on the doll just like the cheap ones, slightly larger to accommodate the insert wall thicknesses. Include 2 closed end 6 inch long (not 4") thin wall inserts.
Statistics: Posted by Poly Skipper — Mon Apr 22, 2024 1:17 pm